Random numbers on the Arduino

/*

Blink

Turns on an LED on for one second, then off for one second, repeatedly.

The circuit:

* LED connected from digital pin 13 to ground.

* Note: On most Arduino boards, there is already an LED on the board

connected to pin 13, so you don't need any extra components for this example.

Created 1 June 2005

By David Cuartielles

http://arduino.cc/en/Tutorial/Blink

based on an orginal by H. Barragan for the Wiring i/o board

*/

int ledPin = 13; // LED connected to digital pin 13

int redLedPin = 12; // LED connected to digital pin 13

int del =500 ;//500;

// The setup() method runs once, when the sketch starts

void setup() {

// initialize the digital pin as an output:

pinMode(ledPin, OUTPUT);

pinMode(redLedPin, OUTPUT);

Serial.begin(9600);

}

// the loop() method runs over and over again,

// as long as the Arduino has power

void loop()

{

digitalWrite(ledPin, HIGH); // set the LED on

digitalWrite(redLedPin, LOW); // set the LED on

Serial.println("Red Low");

delay(del); // wait for a second

digitalWrite(ledPin, LOW); // set the LED off

digitalWrite(redLedPin, HIGH); // set the LED off

delay(del); // wait for a second

}

//Random Numbers Program, generates 100 random numbers between 1 and 10 long randNumber;

void setup(){
Serial.begin(9600);
randomSeed(analogRead(0));
for (int i=0; i<100; randnumber =" random(0,">